Kreg DK1100 FP 1-Spindle Floor Pneumatic Pocket Hole Machine

Quickly position two pocket holes across rails of various widths by placing it against one stop, drilling the hole, and then repeating with the rail against the other stop. For drilling pocket holes in panels, the stops simply swing out of the way.

Adjustments couldn’t be easier. The fence adjusts right from the top side of the machine to let you center a screw in 1/2"- to 1 1/2"-thick material. The clamp hold-down also adjusts to allow materials up to 4"-thick to be drilled.

Changing drill bits is a quick and simple process. Simply loosen the collet with the provided Allen wrench, replace with a new bit, and you are back in production in less than 60 seconds.

The industrial-grade motors used in Kreg machines are built for long-lasting service. Kreg machines are designed to minimize stress on moving parts, greatly reducing the likelihood of failure.

Kreg DK1100 FP 1-Spindle Floor Pneumatic Pocket Hole Machine features:

• Hardened-steel drill guide maximizes drill bit life
• Industrial-grade motor for long-lasting service
• One-touch, pneumatic operation by foot pedal
• Swing Stops for optimized material positioning
• Dust collection chute for efficient chip removal

• Adjustability: Pilot-hole centering in material thickness
• Capacity: Materials from 1/2"- to 1 1/2"-thick
• Power: 1 1/4 HP, 8 CFM at 50% duty cycle (120 PSI/minute)
• Compatibility: DKDB Stepped Drill Bit
• Dimensions: 50"H x 24"W x 24"D (40" table height), 176 lbs.
• Includes: (1) DK1100FP with bits and fittings
• Owner's Manual
• Warranty: 5 years