Amana DT12960-30 Carbide Tipped Sliding Table Saw 12 Inch Dia x 96T ATB, 10 Deg, 30mm Bore

√ Exclusive DITEC™ Carbide Tips

√ Higher Reliability & Lower Maintenance

√ Low Noise Level

√ Laser Cut Saw Bodies

√ Excellent Cutting Quality

Instructions for grinding:

• For maintenance grinding, use fine-grit (D400 to D600) diamond wheels. To match the factory grind, use a slower-than-normal feed rate.
• Damaged teeth can be replaced by any grade of carbide tooth. Replacing of a large number of teeth will, of course, shorten the life of the saw blade.
• Since the carbide in the DITEC™ is harder than other carbides, it is critical that you protect them from “thermal shock” if an adjacent tooth is replaced. Heat absorbed during the brazing process will seriously degrade the DITEC™ carbide.